Adjust or replace Q-Link hinges

Q-Link bands and hinges keep the dome aligned on the base. Thanks to its springs, it makes opening easier and cushions closing. If damaged, it can be replaced. Tools: the same as for the gasket.

1. Remove the dome. Remove the springs, close the dome, then remove the brackets, hinges, and the two rear bolts.

2. Assemble the new band before installing it.

3. Replace. Remove the old band, place the new one on the base by aligning the front holes, then reinstall the dome.

4. Adjust the level. Tighten the rear nuts slightly. The bands must be perfectly level, with at least 3 to 4 mm of green ceramic visible above the bottom band and below the top band. Tighten the bolts, then the hinges and brackets.

5. Check. Reinstall the springs, close the dome, and check for any gaps around the perimeter.

6. Correct if necessary. Slightly loosen the top bolt while the dome is closed. Press down on the dome with a flat palm until the gap disappears, then retighten.